Wds configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wds configuration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wds configuration
Wds configuration
2023-11-09 08:22:49 - last edited 2023-12-05 12:54:10
Model: Archer C64  
Hardware Version: V1
Firmware Version:

I configured my tp link Archer c64 in wds mode by following the instructions from community website and it is working fine, but i can't login into the admin page after the setup. I tried using the new default gateway too but it is only opening old routers admin page rather than the tp link one. Also tried tether app on Android it stopped showing the device after the setup. Need help 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Wds configuration -Solution
2023-11-09 21:39:57 - last edited 2023-12-05 12:54:10

  @Amarvir 

 

The easiest method for resolving this would be to set yor C64 LAN IP address as static - for example:

If your main router operates in the subnet 192.168.1.0/24 and its LAN IP address is 192.168.1.1, its DHCP server pools is 192.168.1.100 - 192.168.1.200, then set the C64 LAN IP address to 192.168.1.254 (in the main router subnet, but outside its DHCP server pool).

When the C64 operates as WDS, you always should be able to access its WebGUI via 192.168.1.254.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  1  
  1  
#2
Options
1 Reply
Re:Wds configuration -Solution
2023-11-09 21:39:57 - last edited 2023-12-05 12:54:10

  @Amarvir 

 

The easiest method for resolving this would be to set yor C64 LAN IP address as static - for example:

If your main router operates in the subnet 192.168.1.0/24 and its LAN IP address is 192.168.1.1, its DHCP server pools is 192.168.1.100 - 192.168.1.200, then set the C64 LAN IP address to 192.168.1.254 (in the main router subnet, but outside its DHCP server pool).

When the C64 operates as WDS, you always should be able to access its WebGUI via 192.168.1.254.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  1  
  1  
#2
Options

Information

Helpful: 0

Views: 291

Replies: 1

Related Articles