Wifi 6 (6Ghz) is just a gimic ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wifi 6 (6Ghz) is just a gimic ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wifi 6 (6Ghz) is just a gimic ?
Wifi 6 (6Ghz) is just a gimic ?
2023-12-29 13:03:02 - last edited 2024-01-02 06:39:09
Model: EAP245  
Hardware Version: V3
Firmware Version: 5.0.6

Hello

 

Wondering if 6Ghz is WIFI 6 and if so is this just a gimic ?

 

I see following

 

Wifi 6Ghz

 

Does this mean that my access points support Wifi 6 (band 6Ghz)?
Bit confused here and needs som input on this subject.

 

Thanks

1x ER-7206 1x C200 2x EAP245 1x SG2008P
  0      
  0      
#1
Options
1 Accepted Solution
Re:Wifi 6 (6Ghz) is just a gimic ?-Solution
2023-12-29 16:59:32 - last edited 2024-01-02 06:39:09

  @ProSumerTester 

 

I think you are mis-interpreting...what you are showing are your Conroller SSID definitions, not the config or capability of the AP.  The controller could apply a profile with 6Ghz to a combination of APs, only some of which are 6Ghz capable.  Personally I don't recommend this, as I have had issues with this exact 'feature', and would up creating two similar SSID profiles...one for 6Ghz capable devices and one for those that aren't.

<< Paying it forward, one juicy problem at a time... >>
Recommended Solution
  0  
  0  
#4
Options
3 Reply
Re:Wifi 6 (6Ghz) is just a gimic ?
2023-12-29 15:12:48 - last edited 2023-12-29 15:13:55

  @ProSumerTester EAP245 only supports 2.4GHz and 5GHz. WiFi 6 is different, and is applicable to 2.4GHz and 5GHz on your access point. 

  0  
  0  
#2
Options
Re:Wifi 6 (6Ghz) is just a gimic ?
2023-12-29 15:15:31

  @Landfall2624 

..so that 6Ghz that I am seeing on my AP is not usable (gimic as I mentioned previously )?

1x ER-7206 1x C200 2x EAP245 1x SG2008P
  0  
  0  
#3
Options
Re:Wifi 6 (6Ghz) is just a gimic ?-Solution
2023-12-29 16:59:32 - last edited 2024-01-02 06:39:09

  @ProSumerTester 

 

I think you are mis-interpreting...what you are showing are your Conroller SSID definitions, not the config or capability of the AP.  The controller could apply a profile with 6Ghz to a combination of APs, only some of which are 6Ghz capable.  Personally I don't recommend this, as I have had issues with this exact 'feature', and would up creating two similar SSID profiles...one for 6Ghz capable devices and one for those that aren't.

<< Paying it forward, one juicy problem at a time... >>
Recommended Solution
  0  
  0  
#4
Options