No NAT Loopback on EX510 AX3000 Dual-Band Gigabit Wi-Fi 6 Router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

No NAT Loopback on EX510 AX3000 Dual-Band Gigabit Wi-Fi 6 Router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TB37

2024-01-14 05:13:01

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-01-14

No NAT Loopback on EX510 AX3000 Dual-Band Gigabit Wi-Fi 6 Router

2024-01-14 05:13:01

Model: Archer AX3000

Hardware Version: V1

Firmware Version: The latest one

I'm using this router: https://www.tp-link.com/sg/service-provider/wifi-router/ex510/

However, I discovered that it does not have NAT loopback (hair pinning). Is there a way to configure the static routing to mimic this? Or is there a firmware that allows NAT loopback?

Much appreciated for your help!

1 Reply

terziyski

LV7

2024-01-14 15:59:08

Posts: 7133

Helpful: 5344

Solutions: 1210

Stories: 7

Registered: 2013-10-12

Re:No NAT Loopback on EX510 AX3000 Dual-Band Gigabit Wi-Fi 6 Router

2024-01-14 15:59:08

@TB37

Unfortunately the routers that are service-provider offered are not supported by TP-Link and their FW can be obtained only from the ISP providing the router.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

No NAT Loopback on EX510 AX3000 Dual-Band Gigabit Wi-Fi 6 Router

No NAT Loopback on EX510 AX3000 Dual-Band Gigabit Wi-Fi 6 Router

Information

Voters 0

Tags