Archer A8 hairpin nat
Hello,
how can I turn on hairpin NAT? Archer A8 device.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi, Archer A8 does supports NAT Loopback and it is enabled by default as @terziyski mentioned.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@terziyski Thanks for the information - but how I can check if my A8 Archer supports NAT loopback?
What I would like use this technology for the purposes of using CCTV and private could both inside and outside my network.
E.G. if my public IP is 31.31.199.199 and local IP for this server is 192.168.0.101 I would like to redirect packages from the first one to the second IP inside my network (to shorten the connection and avoid unnecessary going packages outside network and coming back again).
- Copy Link
- Report Inappropriate Content
There's two ways to know that:
1. Follow the steps in the story I posted and check if NAT loopback is working on your router.
2. A TP-Link representative to confirm that Archer A8 supports NAT loopback.
- Copy Link
- Report Inappropriate Content
Thanks for the reply, I've asked TP-Link support, but no response for now yet...
- Copy Link
- Report Inappropriate Content
Hi, Archer A8 does supports NAT Loopback and it is enabled by default as @terziyski mentioned.
- Copy Link
- Report Inappropriate Content
@Sunshine Thank for that!
But how can I setup this feature?
I would like to set sth like:
/ip firewall nat add chain=srcnat src-address=133.133.1.1/443 dst-address=192.168.10.102 out-interface=LAN action=masquerade
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 485
Replies: 7
Voters 0
No one has voted for it yet.