Routing between “Branch” (VPN) sites.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Routing between “Branch” (VPN) sites.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

BAchorn

2024-03-21 20:47:26 - last edited 2024-03-22 01:05:15

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-03-21

Routing between “Branch” (VPN) sites.

2024-03-21 20:47:26 - last edited 2024-03-22 01:05:15

Model: ER8411

Hardware Version: V1

Firmware Version: 1.2.0

I have an NHQ site (ER8411 fw1.2.0) with multiple "Branch" sites (ER7206 fw1.4.1). They are all managed by a single controller (OC200 5.13.24) and all the branchs are connected to the NHQ site via "manual" IPsec VPNs (could not get Auto IPsec to work). I want the branchs to be able to access each others resource in addition to the NHQ resources. At the moment in this spoke/hub configuration each branch can only access the NHQ resources (while NHQ can access all the branchs). How can I configure the routing table to allow inter-branch access without creating VPN tunnels directly between the branch's?

Thanks