er8411 SFP+ WAN1 greyed out
trying to configure the sfp+ wan1 port but the port is greyed out in the web broswer standlone settings on the network>wan page. So unable to tick it to enable it is wan. also i was expecting to an option somewhere for flow control but i do not see any option to enable or disable on other ports i have configured as wan.
tx.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi all,
Here's why and what happened.
If you experience the issue, note that this was a problem when you disabled the SFP+ from WAN and later on you upgraded the firmware to the latest and the option is not listed anymore.
We offer you a beta but requires you to repeat the same steps - download
You are required to set the port to WAN mode again: In Standalone, go to Network -> WAN -> WAN mode.
This will get it back and you can use it again.
We will address this issue in future firmware upgrades.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2169
Replies: 21
Voters 0
No one has voted for it yet.