EAP225 V3 Outdoor Crashing

EAP225 V3 Outdoor Crashing

EAP225 V3 Outdoor Crashing
EAP225 V3 Outdoor Crashing
2024-04-06 15:20:32
Model: EAP225-Outdoor  
Hardware Version: V3
Firmware Version: 5.1.1
Hello,

I just installed an EAP225 Outdoor and had the misfortune of seeing the device stop working after less than 24 hours of use. It is necessary to remove it from the socket and replace it to start working again. It is common? What should I do to prevent this freezing from happening again?

My infra is as follows:

I have a Mikrotik RB4011, connected to an Omada Controller and just an EAP225 Outdoor for now.
  0      
  0      
#1
Options
4 Reply
Re:EAP225 V3 Outdoor Crashing
2024-04-06 18:47:52

  @ICB 

 

Plug the AP directly into the router, not via the controller (assuming you have a hardware controller).

 

Ensure that your controller's management VLAN is a member of and untagged on the AP port, and as well all SSID VLANs should be present on the AP port and tagged.

 

I recommend fixing/reserving the IP address of the controller and assigning it via DHCP.

 

Did you change the default management LAN from 192.168.0.0/24 ?

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#2
Options
Re:EAP225 V3 Outdoor Crashing
2024-04-11 00:17:08
Hello, d0ugmac1Nv5! I have an RB4011 with Vlan for the administrative network and Vlan for the public network. The Vlans are distributed without Easy Smart 1024DE Gigabit Switch. The AP is not connected directly to the controller, it is connected to the Switch and receives a VLAN on the Switch port. A Vlan is not configured without an AP view and will receive information on the Switch port. The Lan of the controller and the AP are permanently set to factory settings, via DHCP. The latest firmware update was recently released, but the note that a speech is installed is then normalized into a speech the moment the AP is used. The equipment is still under observation and operation. At the moment, the problem cannot be seen now.
  0  
  0  
#3
Options
Re:EAP225 V3 Outdoor Crashing
2024-04-29 19:56:25

The problem actually persists, the router appears to be unable to support around 50 connections and simply shuts down. Bad time to change brands, I was using the Ubiquiti Nano Loco M2 and it worked, it never crashed. I do not know what else to do. Should I claim the warranty?

  0  
  0  
#4
Options
Re:EAP225 V3 Outdoor Crashing
2024-08-28 12:02:00 - last edited 2024-08-28 12:06:43

  @ICB 

Be carefull with the FallBack IP setting of the Access point.

Turn off the fallback ip or you have to give different ips to each Access point (192.168.0.200 , 192.168.0.201 etc)

The access points stop working when they starts without a dhcp server on your network and the fallback ip is same on all.

You have to turn off and on to work again !!!!!

  0  
  0  
#5
Options