Help me,switches in omada in unstable status,in 5 Seconds/between(Connected,hearbeat, disconnected)?
Help me,switches in omada in unstable status,in 5 Seconds/between(Connected,hearbeat, disconnected , adopting , adopt fails)?
look at picture please
i checked all stp settings all configuration all ports in STP and Core switch with 8096 and other switches in 24546 STP number,
please help me what i can do to detect the problems ???
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @MeowMeow
Thanks for posting in our business forum.
There is no better way to fix it.
Here are some my suggestions:
1. Reset it and adopt it again. Will this persist? If it persists, it should be a problem with your cabling.
2. Check the wires and cabling. Something must be connected incorrectly. STP, if you did not enable and apply the settings to this specific switch(troubled one), it does not work for this one. And this might persist.
3. Remove unnecessary cables and find out if it is other devices looped instead of the switch.
Enable the STP on the rest of the switch. Check your log to see if there are any blocks.
A Port Being Blocked Showing in Controller Log - "xyz's port Gi 1/0/X Was Blocked"
- Copy Link
- Report Inappropriate Content
Hi @MeowMeow
Thanks for posting in our business forum.
There is no better way to fix it.
Here are some my suggestions:
1. Reset it and adopt it again. Will this persist? If it persists, it should be a problem with your cabling.
2. Check the wires and cabling. Something must be connected incorrectly. STP, if you did not enable and apply the settings to this specific switch(troubled one), it does not work for this one. And this might persist.
3. Remove unnecessary cables and find out if it is other devices looped instead of the switch.
Enable the STP on the rest of the switch. Check your log to see if there are any blocks.
A Port Being Blocked Showing in Controller Log - "xyz's port Gi 1/0/X Was Blocked"
- Copy Link
- Report Inappropriate Content
Dear i did what you tell me ,
i measured fibers cable between to ends with devices for mesurement and the db loss is between - 1.5 and -2.5 db
But
when i measure db signal that exit from tp link SFP module the signal is between -17 and -22
is that ok ??
or the problem from SFP module ? cause this happen with more than 10 SFP modules
waiting your help
- Copy Link
- Report Inappropriate Content
Hi @MeowMeow
Thanks for posting in our business forum.
MeowMeow wrote
Dear i did what you tell me ,
i measured fibers cable between to ends with devices for mesurement and the db loss is between - 1.5 and -2.5 db
But
when i measure db signal that exit from tp link SFP module the signal is between -17 and -22
is that ok ??
or the problem from SFP module ? cause this happen with more than 10 SFP modules
waiting your help
I don't have a comment or standard on the signal value you mentioned.
As I have already instructed you to do the troubleshooting one by one to filter and locate the problems.
- Copy Link
- Report Inappropriate Content
Ok , problem with SFP Modules , sending low signal dbm , TX Power is -25dbm , after change it with new sfp module now its -3dbm
now its working like charm 
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 490
Replies: 4
Voters 0
No one has voted for it yet.