P9 Flashing red but app says fine

P9 Flashing red but app says fine

P9 Flashing red but app says fine
P9 Flashing red but app says fine
2024-06-05 15:10:36

I have a network of 5 x P9. One satellite has started flashing red despite close proximity (5') from main deco.

 

firmware is up to date.
 

Reboot won't work and switching on and off doesn't either. 


The App doesn't show there is any issue. 

  0      
  0      
#1
Options
1 Reply
Re:P9 Flashing red but app says fine
2024-06-07 02:10:15 - last edited 2024-06-07 02:10:45

  @Sjrzx7r 

Hi,

 

You can use a wired device to connect to this unit directly. If the internet is working normally, then it is the Deco LED not showing correctly.

 

If it is not working, just reset the Deco unit and then add it again.

If it is still the same after you reset and reconfigure, please contact TP-Link technical support to check the warranty for you.

 

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options