LLDP in Omada topology map

LLDP in Omada topology map

LLDP in Omada topology map
LLDP in Omada topology map
2024-07-01 04:36:57 - last edited 2024-07-05 08:03:24

I noticed that the topology map in the Omada controller says this:

 

"To ensure the accurate topology, please enable LLDP."

 

My core switch is a MikroTik CRS312-4C+8XG-RM. It has LLDP enabled and I can see it using lldpcli from my PC:

 

Interface:    enp4s0, via: LLDP, RID: 1, Time: 0 day, 01:08:55
 Chassis:      
   ChassisID:    mac 18:fd:xx:xx:xx:xx
   SysName:      CRS312
   SysDescr:     MikroTik RouterOS 7.11.2 (stable) Aug/31/2023 13:55:47 CRS312-4C+8XG
   MgmtIP:       10.1.0.2
   MgmtIface:    2
   Capability:   Bridge, on
   Capability:   Router, on
 Port:         
   PortID:       ifname bridge/ether2
   TTL:          120


 

However, it does not appear in the map on the Omada controller.

 

Is there something else I need to do to show data collected via LLDP on the map?

https://d.sb/ My setup: 10Gbps fiber internet, ER8411, 2 x EAP670, Mikrotik CRS312-4C+8XG-RM, Omada software controller in Docker.
  0      
  0      
#1
Options
1 Accepted Solution
Re:LLDP in Omada topology map-Solution
2024-07-02 06:29:11 - last edited 2024-07-05 08:03:24

 hi,  @Dan15 

The controller can only detect TP-Link SDN devices and display them on the Topology Map page.

For those third-party switches or non-SDN switches, they will be shown as lines.

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:LLDP in Omada topology map-Solution
2024-07-02 06:29:11 - last edited 2024-07-05 08:03:24

 hi,  @Dan15 

The controller can only detect TP-Link SDN devices and display them on the Topology Map page.

For those third-party switches or non-SDN switches, they will be shown as lines.

Recommended Solution
  0  
  0  
#2
Options