Home Network Community > Wi-Fi Routers > AX11000 using RE105
< Wi-Fi Routers

AX11000 using RE105

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AX11000 using RE105

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
AX11000 using RE105
AX11000 using RE105
2024-07-03 23:56:15 - last edited 2024-07-05 01:44:34
Model: Archer AX11000  
Hardware Version: V1
Firmware Version: 1.3.4 Build 20230906 rel.74809

Greetings!

 

So i have my AX11000 set up working fine for over 2yrs...ZERO issues with the router and modem setup. 

 

So recently I been having all sorts of issues with the RE105 being used as a repeater.  Mind you, its been working pretty well for the past 2 years.  Out of nowhere, the RE105's DO NOT stay connected at all in the Tether app.  I have removed them and reinstalled, reflashed them, set back up to a competely unstable connection.  

 

 

 

Im at a complete loss.  The AX11000 signal doesnt reach my entire house, so the 105's were used to repeat. 

 

Any insight on how I should tackle this?  

Is it time to upgrade the repeaters?  or is the Mesh system even any good?...

  0      
 
  0      
 
#1
Options
1 Reply
Re:AX11000 using RE105
2024-07-04 14:52:11 - last edited 2024-07-05 01:44:11

  @rbb213 

 

Use these guides on how to place your devices for optimal reception and performance.

For routers

For range extenders

If after that there's no improvement in RE105 performance you probably have to consider replacing the RE (with a higher model like RE705X, which supports mesh as well).

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 353

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.