Home Network Community > Deco > DECO X60 Wifi capped at 500Mbps
< Deco

DECO X60 Wifi capped at 500Mbps

DECO X60 Wifi capped at 500Mbps

DECO X60 Wifi capped at 500Mbps
DECO X60 Wifi capped at 500Mbps
a week ago - last edited a week ago
Model: Deco X60  
Hardware Version: V3
Firmware Version: 1.3.0 Build 20240830 Rel. 50008

Hello

today i had a new FTTP installed, it should be 960/960Mbps but currently seem to be capped on Wifi 5Ghz at around 550Mbps
I have a cabled connection that i run on a cron to speedtest and this hits a much more respectable amout, my Macbook is connected at 1200Mbps (ax) as all the screenshots show etc, tried enable / disable QOS but didnt make any difference, always capped at around 500 / 550
any ideas ?

speedtest via wifi

 

speed via cable (via grafana with prometheus exporter)

e7cfb4ed06784b12a57692b2fee3fc95

 

channels set to 160 Mhz
6d5c754c8f504131a7a27fc0e0f7f4fd

 

i also have a thinkbroadband monitor running for ping latency / packet loss, since swapping to the new connection the Tplink DNS is not working 

cc5810b43cfb40209fc7c691eed458f5

i createrd a new one using opendns endpoint that works OK (although its so new its hard to see but its in the bottom right corner)
2ffa61a3a7034be3ac234a56ec83ee80

  1      
 
  1      
 
#1
Options
1 Accepted Solution
Re:DECO X60 Wifi capped at 500Mbps-Solution
a week ago - last edited a week ago

  @Deejc 

 

Hi, thanks for your update.

As per the specifications of Deco X60, 4804 Mbps (802.11ax) on 5GHz refer to the maximum link speed, not actual internet speed.

The fact is the actual wireless link speed on your Macbook is 1200 Mbps. And when devices connect the wireless network, they follow half-duplex negotiation principle(which is suitable for all wireless devices.), so the internet speed on your Macbook is about 40%-50% of the link speed.

If you have phones or other wirless devices, you may test and verify referring to this guide.

Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode.
Recommended Solution
  0  
  0  
#7
Options
7 Reply
Re:DECO X60 Wifi capped at 500Mbps
a week ago

i also tested this locally running Iperf on a Cable connected device and i see similar speeds on Wifi
 

❯ iperf3-darwin -c 192.168.1.100 -bidir

Connecting to host 192.168.1.100, port 5201

[  5] local 192.168.1.122 port 59343 connected to 192.168.1.100 port 5201

[ ID] Interval           Transfer     Bitrate         Retr  Cwnd          RTT

[  5]   0.00-1.00   sec  77.0 MBytes   646 Mbits/sec    0   2.14 MBytes   19ms     

[  5]   1.00-2.00   sec  78.6 MBytes   658 Mbits/sec    0   2.26 MBytes   18ms     

[  5]   2.00-3.00   sec  71.2 MBytes   598 Mbits/sec    0   2.35 MBytes   22ms     

[  5]   3.00-4.00   sec  75.8 MBytes   636 Mbits/sec    0   2.43 MBytes   17ms     

[  5]   4.00-5.00   sec  71.0 MBytes   596 Mbits/sec    0   2.48 MBytes   52ms     

[  5]   5.00-6.00   sec  77.9 MBytes   653 Mbits/sec    0   2.51 MBytes   23ms     

[  5]   6.00-7.00   sec  79.3 MBytes   665 Mbits/sec    0   2.53 MBytes   108ms     

[  5]   7.00-8.01   sec  72.3 MBytes   603 Mbits/sec    0   2.54 MBytes   21ms     

[  5]   8.01-9.00   sec  81.3 MBytes   683 Mbits/sec    0   2.55 MBytes   30ms     

[  5]   9.00-10.00  sec  76.6 MBytes   645 Mbits/sec    0   2.55 MBytes   25ms     

- - - - - - - - - - - - - - - - - - - - - - - - -

[ ID] Interval           Transfer     Bitrate         Retr

[  5]   0.00-10.00  sec   761 MBytes   638 Mbits/sec    0             sender

[  5]   0.00-10.02  sec   759 MBytes   636 Mbits/sec                  receiver

 

iperf Done.

 

  1  
  1  
#2
Options
Re:DECO X60 Wifi capped at 500Mbps
a week ago

  @Deejc 

 

Hi, thanks for posting question.

According to your sharing, the wireless internet speed on your Macbook on 5GHz band is normal.

You may refer to the articles below to know more:

Wireless speed is not expected? Get to know about TCP BBR!

Troubleshooting Slow Speed on the Main Deco

Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode.
  0  
  0  
#3
Options
Re:DECO X60 Wifi capped at 500Mbps
a week ago

  @Marvin_S 

hello thanks for the reply, I'm not sure I understand the 1st link, but I checked my deco system and none of the items mentioned in the 2nd link are active 

I ran iperf locally and the speeds are the same, so is tcp brr somehow active on the deco units ? It says deco x60 is capable of up to 4000+ mbps in the adverts 

  0  
  0  
#4
Options
Re:DECO X60 Wifi capped at 500Mbps
a week ago - last edited a week ago

i think i found some issues, my new ISP seems to do CGNAT on IPV4, but it does native IPV6, i have set my Deco to have an IPV6 and that seems to work fine, the speeds are still the sort of the same though

 


and here is my wired testing shown in grafana

  0  
  0  
#5
Options
Re:DECO X60 Wifi capped at 500Mbps
a week ago - last edited a week ago

@Marvin_S  here are 2 speedtests, i feel this concludes that the WIFI is the issue here, not my Laptop

first one my Macbook connected directly to the ONT via Ethernet


and 2nd, to a gigabit switch connected to the LAN port on the Main Deco (Wifi is connected tothe Main Deco)

  1  
  1  
#6
Options
Re:DECO X60 Wifi capped at 500Mbps-Solution
a week ago - last edited a week ago

  @Deejc 

 

Hi, thanks for your update.

As per the specifications of Deco X60, 4804 Mbps (802.11ax) on 5GHz refer to the maximum link speed, not actual internet speed.

The fact is the actual wireless link speed on your Macbook is 1200 Mbps. And when devices connect the wireless network, they follow half-duplex negotiation principle(which is suitable for all wireless devices.), so the internet speed on your Macbook is about 40%-50% of the link speed.

If you have phones or other wirless devices, you may test and verify referring to this guide.

Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode.
Recommended Solution
  0  
  0  
#7
Options
Re:DECO X60 Wifi capped at 500Mbps
a week ago
Ok I see, thanks for the links and explanation
  1  
  1  
#8
Options

Information

Helpful: 1

Views: 162

Replies: 7

Related Articles
Change wifi channel on Deco X60
36247 13
Does the Deco X60 require a wifi-6 router ??
1627 0
DECO X60 and DECO E4
1335 0
My Deco M4 capped at 100MBPS only
246 0
Deco x60 latency
505 0
Deco X60 + Powerline
842 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.