Home Network Community > Deco > Connecting different eco models
< Deco

Connecting different eco models

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Connecting different eco models

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Connecting different eco models
Connecting different eco models
2024-12-19 02:21:33 - last edited 2024-12-19 02:23:00

I recently upgraded my home WiFi to ghz speed and have an X55 3 pack that are working fine. I have an older DSL E4R pack and would like to know if the models are compatible. I want to put the E4R's in my shed, and garage. I tried to add the E4R's thru the deco app, but it does not see/find the E4R's. Pls note I have the X55 set at 5GHz

  0      
 
  0      
 
#1
Options
3 Reply
Re:Connecting different eco models
2024-12-19 10:05:54

  @JohnMerlin 

 

Hi, welcome to our community.

Different Decos can work together.

When addding E4, please power it on in the same room where the main X55 is. After setting it up successfully, you may relocate to the place you want.
How to add an additional unit to your Deco network

Can different Deco models work together?

Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode.
  0  
  0  
#2
Options
Re:Connecting different eco models
2024-12-19 23:20:50

  @Marvin_S  this is exactly what I have done but the deco app, while searching for the other decos (E4R) does not find them. I've tried powering them on and off. I even had them next to the deco base connected to the router.

  0  
  0  
#3
Options
Re:Connecting different eco models
2024-12-23 02:01:21

  @JohnMerlin 

 

Hi, here are some further suggestions for your reference:

1. Make sure factory reset was taken first.

2. You may turn on 2.4GHz and 5GHz of the current Deco network temporarily on app to confirm whether it helps.

3. Please connect Deco E4 to your main Deco via an Ethernet cable and set it up for a try.

Thank you and best regards.

Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode.
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 410

Replies: 3

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.