Good day,

os Win11

I have used the UE200 (USB2) tp-link device for various eth-usb connectivity for more than 18 months , worked well.

Serial : 22436T6008839 UN/2.0

Recently ~2months ago the faithfull TP-LINK device failed.

I thought, best let me replace it with new, and, plug-in, just worked.

until recencty, as in past week, when next I plugged into USB3 Port,

it enumarated briefly (could see it in Dev Manager / Network adaptors) afterwhich it disconnects,

(not visible in Network Adaptors)  and then finally win11 msg  >>  hereunder --

 

Today --I have another brand-new out of box unit, plugged-in, enumerates, working -

Disable/Enable in networking settings to change ip settings 3 times,

afterwhich the unit failed and does now the same as described above, img below.

 

What I have tried --

1 On Laptop -- Switch OFF / ON  -- same issue

2 Use the Laptop direct port (USB3)

3 When the tp-link registered on Network Adaptor,

before it de-registers-

I was able to look at its properties / driver/  win11 reports it is the latests/updated drive

 

So now I have 2 units FUBAR within a period of a week.

 

I now not willing to buy another unit, since this may occur again

 

Is there someone who can please help me --

 

If a TP-Link support Engineer want to remote connect to my laptop to investigate, please advise contact me, even by emial.

 

Please help

 

Thank you