Network printer config
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Since installing the mesh system I am unable to access network printers via my ethernet hardwired 24 port unmanaged switch. All other hardwired components are working fine through switch. Is there a config setting for printers?
Please help
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, welcome to our community.
May I confirm some information to understand your situation better?
1. What is your exact network topology? How is the unmanaged switch connected? How are the Deco units are connected to each other?
2. What is your model of your switch? What are the models of your network printers?
3. Please connect your printer one Deco directly via Ethernet cable to confirm whether it can work.
4. Please try different port on your switch and try different Ethernet cable.
5. Confirm if your printer has a static IP address or not. If so, change the IP settings on the printer to obtain an IP address automatically.
Thank you and best regards.
- Copy Link
- Report Inappropriate Content
Hi, welcome to our community.
May I confirm some information to understand your situation better?
1. What is your exact network topology? How is the unmanaged switch connected? How are the Deco units are connected to each other?
2. What is your model of your switch? What are the models of your network printers?
3. Please connect your printer one Deco directly via Ethernet cable to confirm whether it can work.
4. Please try different port on your switch and try different Ethernet cable.
5. Confirm if your printer has a static IP address or not. If so, change the IP settings on the printer to obtain an IP address automatically.
Thank you and best regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 200
Replies: 1
Voters 0
No one has voted for it yet.