Unable to get past blinking yellow
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi, it's a struggle to set up Deco x50 AX3000 whole mesh system as when plugged in I get nothing but flashing yellow light.
have tried different units, different sockets to no avail.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, welcome to our community.
Here are some suggestions for your reference:
1. Change another power adapter.
2. Factory reset.
3. Try firmware recovery following this guide
If the steps above do not help, it is suggested to contact retailer or local support team to confirm warranty.
Thank and best regards.
- Copy Link
- Report Inappropriate Content
Hi, welcome to our community.
Here are some suggestions for your reference:
1. Change another power adapter.
2. Factory reset.
3. Try firmware recovery following this guide
If the steps above do not help, it is suggested to contact retailer or local support team to confirm warranty.
Thank and best regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 220
Replies: 1
Voters 0
No one has voted for it yet.