TG-3268 Flow control
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TG-3268 Flow control
Region : Brazil
Model : TG-3468
Hardware Version : V2
Firmware Version :
ISP :
I installed the network adapter TG-3468 in my desktop with Linux Fedora 19 and I wish to enable/disable flow control.When I use the ethtool -a command the output said that the operation is not supported. Do I need to set a parameter in linux or in the network adapter to enable/disable flow control ?
# ethtool -a p2p1
Pause parameters for p2p1:
Cannot get device pause settings: Operation not supported
Thank you for any help.
Model : TG-3468
Hardware Version : V2
Firmware Version :
ISP :
I installed the network adapter TG-3468 in my desktop with Linux Fedora 19 and I wish to enable/disable flow control.When I use the ethtool -a command the output said that the operation is not supported. Do I need to set a parameter in linux or in the network adapter to enable/disable flow control ?
# ethtool -a p2p1
Pause parameters for p2p1:
Cannot get device pause settings: Operation not supported
Thank you for any help.