Struggling to setup inbound connections
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Struggling to setup inbound connections
Region : UnitedKingdom
Model : TL-WDR3600
Hardware Version : V1
Firmware Version :
ISP :
Just installed the above router.. love the product, works well, wireless great, everything very good.
Upgraded from a Netgear N150.
Having one issue, which I am sure is relatively easy but bit more technical than the last router. Previously on the old router, in firewall I could set up inbound services really easy. Enable it, tell it the service name, say either block or allow, input the LAN IP address and then the WAN IP address of the external client needing access through the firewall. Took 30 seconds and was set up immediately.
I have tried to see how I would do the same on the tp3600, but its proving a bit more confusing.
Can somebody point me in the direction???
Cheers
Model : TL-WDR3600
Hardware Version : V1
Firmware Version :
ISP :
Just installed the above router.. love the product, works well, wireless great, everything very good.
Upgraded from a Netgear N150.
Having one issue, which I am sure is relatively easy but bit more technical than the last router. Previously on the old router, in firewall I could set up inbound services really easy. Enable it, tell it the service name, say either block or allow, input the LAN IP address and then the WAN IP address of the external client needing access through the firewall. Took 30 seconds and was set up immediately.
I have tried to see how I would do the same on the tp3600, but its proving a bit more confusing.
Can somebody point me in the direction???
Cheers