How to change SYSTEM default gateway when WAN is disconnected
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to change SYSTEM default gateway when WAN is disconnected
Region : Belgium
Model : TL-WDR4300
Hardware Version : V1
Firmware Version : 3.13.33 Build 130617
ISP : Dommel.be
Hi
My WDR4300 N750 is in use as wifi access point with no WAN connection since another device is used for internet connection. But since there is no WAN port connected, there is no default gateway set. When I look at the system routing table, I see only the IP address and subnetmask, but the gateway is set to 0.0.0.0. And I can't find any place where I could set the default gateway.
Any tips? Maybe SSH into the command line and change the routing table myself but how do i get in?
Model : TL-WDR4300
Hardware Version : V1
Firmware Version : 3.13.33 Build 130617
ISP : Dommel.be
Hi
My WDR4300 N750 is in use as wifi access point with no WAN connection since another device is used for internet connection. But since there is no WAN port connected, there is no default gateway set. When I look at the system routing table, I see only the IP address and subnetmask, but the gateway is set to 0.0.0.0. And I can't find any place where I could set the default gateway.
Any tips? Maybe SSH into the command line and change the routing table myself but how do i get in?