How to change SYSTEM default gateway when WAN is disconnected

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to change SYSTEM default gateway when WAN is disconnected

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to change SYSTEM default gateway when WAN is disconnected
How to change SYSTEM default gateway when WAN is disconnected
2015-02-28 02:10:11
Region : Belgium

Model : TL-WDR4300

Hardware Version : V1

Firmware Version : 3.13.33 Build 130617

ISP : Dommel.be


Hi
My WDR4300 N750 is in use as wifi access point with no WAN connection since another device is used for internet connection. But since there is no WAN port connected, there is no default gateway set. When I look at the system routing table, I see only the IP address and subnetmask, but the gateway is set to 0.0.0.0. And I can't find any place where I could set the default gateway.

Any tips? Maybe SSH into the command line and change the routing table myself but how do i get in?
  0      
  0      
#1
Options
2 Reply
Re:How to change SYSTEM default gateway when WAN is disconnected
2015-02-28 13:54:20
Did you try to configure static routing on WDR4300?
http://www.tp-link.com/en/article/?faqid=560
  0  
  0  
#2
Options
Re:How to change SYSTEM default gateway when WAN is disconnected
2015-02-28 16:01:44

M Diamond wrote

Did you try to configure static routing on WDR4300?
http://www.tp-link.com/en/article/?faqid=560


Yes, but that is not possible. If done correctly I should set the following route:
network: 0.0.0.0
subnetmask: 0.0.0.0
Gateway: 192.168.0.254

But the network and subnetmask are invallid according to the interface. :-(
  1  
  1  
#3
Options

Information

Helpful: 0

Views: 1772

Replies: 2