Still can't access even after i reset

Still can't access even after i reset

Still can't access even after i reset
Still can't access even after i reset
2025-04-18 17:24:54 - last edited 2025-05-18 15:54:07
Model: RE450  
Hardware Version: V4
Firmware Version:

I have tried setting up my extender but it did not work, so i moved closer to the router and connected it again, and it stopped allowing me to even connect. Not with the factory password and not with the password i had set up while configuring. So i tried factory reseting by holding the button for 10 seconds and it still will not allow me to connect. Please help.

  0      
  0      
#1
Options
1 Accepted Solution
Re:Still can't access even after i reset -Solution
2025-04-21 02:50:22 - last edited 2025-05-18 15:54:07

  @wilhelm1 

 

Hi, welcome to our community.

It is suggested to follow the two guides below:
How to configure Range Extender via Tether APP

What should I do if I fail to configure TP-Link Range Extender?

Thank you and best regards.

 

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Still can't access even after i reset -Solution
2025-04-21 02:50:22 - last edited 2025-05-18 15:54:07

  @wilhelm1 

 

Hi, welcome to our community.

It is suggested to follow the two guides below:
How to configure Range Extender via Tether APP

What should I do if I fail to configure TP-Link Range Extender?

Thank you and best regards.

 

Recommended Solution
  0  
  0  
#2
Options