Connected Clients Name Back To Default in Deco App
Hey TP-LINK !!
Why my connected clients name back to default in Deco App after few hours or next day? I was facing the same problem on previous firmware like 1.6.5 and others but i have'nt faced this problem on Deco X20 only facing this on Deco M4 when i use the custom name of connected client so the name not always remain same. This is my brother's Redmi Note 10S when i changed the name from default name to Redmi Note 10S but the name back to default after few hours or next day and exact same problem with IoT devices names too. @David-TP
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Marvin_S My issue has been resolved when i give my client devices a static ip address and after that names are always remain same.
- Copy Link
- Report Inappropriate Content
Hi, thanks for posting question here.
First, it is suggested to submit Deco app log using email address you registered on our community following this thread.
What are the exact models of the affected devices?
You may turn off random Mac Address of these devices and check again.
Thanks for your cooperation and best regards.
- Copy Link
- Report Inappropriate Content
@Marvin_S I tried to turned OFF Randomized MAC Address and still same problem and i also tried to change IoT Devices names and still same problem.
- Copy Link
- Report Inappropriate Content
Hi, what are the models of your IoT devices?
It seems that we still did not receive your app log.
Waiting for your reply and best regards.
- Copy Link
- Report Inappropriate Content
@Marvin_S My issue has been resolved when i give my client devices a static ip address and after that names are always remain same.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 207
Replies: 4
Voters 1
