Deco home network
I just made new Deco wifi home network based on six X50 POE . One of them is a main and the others are sattelite. All are connected by ethernet to POE switch old TP Line TL-SG1008 PE and through that switch to internet ( Star Link).
After configuration ( following instruction close to the main) 2 of the sattelites work well and 3 don't- pulsing red light appears.
Can anyone help?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Adam4400 If I understand your setup, you should change to Access Point mode.
If you want to remain in Router mode, you should change your connectivity, from [starlink <> switch <> all Deco] to [starlink <> main Deco <> switch <> satellite Deco].
In Router mode, the main Deco must use one port to connect to Internet, and other port(s) to connect to the satellite Deco.
- Copy Link
- Report Inappropriate Content
@Adam4400 What is the operation mode of the Deco mesh: router or access point?
- Copy Link
- Report Inappropriate Content
@yves_b Router mode
- Copy Link
- Report Inappropriate Content
@Adam4400 If I understand your setup, you should change to Access Point mode.
If you want to remain in Router mode, you should change your connectivity, from [starlink <> switch <> all Deco] to [starlink <> main Deco <> switch <> satellite Deco].
In Router mode, the main Deco must use one port to connect to Internet, and other port(s) to connect to the satellite Deco.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 92
Replies: 3
Voters 0
No one has voted for it yet.