Home Network Community > Deco > Deco home network
< Deco

Deco home network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco home network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco home network
Deco home network
2025-05-10 08:47:02 - last edited 2025-05-12 07:21:19
Model: Deco X50 - PoE  
Hardware Version:
Firmware Version:

I just made new Deco wifi home network based on six X50 POE . One of them is a main and the others are sattelite. All are connected by ethernet to POE switch old TP Line TL-SG1008 PE and through that switch to internet ( Star Link). 
After configuration ( following instruction close to the main) 2 of the sattelites work well and 3 don't- pulsing red light appears. 
Can anyone help? 

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Deco home network-Solution
2025-05-10 21:09:35 - last edited 2025-05-12 07:21:19

  @Adam4400 If I understand your setup, you should change to Access Point mode.

 

If you want to remain in Router mode, you should change your connectivity, from [starlink <> switch <> all Deco] to [starlink <> main Deco <> switch <> satellite Deco].

In Router mode, the main Deco must use one port to connect to Internet, and other port(s) to connect to the satellite Deco.

Recommended Solution
  0  
  0  
#4
Options
3 Reply
Re:Deco home network
2025-05-10 13:34:49

  @Adam4400 What is the operation mode of the Deco mesh: router or access point?

  0  
  0  
#2
Options
Re:Deco home network
2025-05-10 18:09:34

  @yves_b Router mode

  0  
  0  
#3
Options
Re:Deco home network-Solution
2025-05-10 21:09:35 - last edited 2025-05-12 07:21:19

  @Adam4400 If I understand your setup, you should change to Access Point mode.

 

If you want to remain in Router mode, you should change your connectivity, from [starlink <> switch <> all Deco] to [starlink <> main Deco <> switch <> satellite Deco].

In Router mode, the main Deco must use one port to connect to Internet, and other port(s) to connect to the satellite Deco.

Recommended Solution
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 253

Replies: 3

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.