TP Link TM-IP5600 caller ID function does not work
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP Link TM-IP5600 caller ID function does not work
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
Hi:
I am trying to use the Caller ID Function of the TPLink TM-IP5600 but it does not work. I have try to use Putty 0.65 and use the following connection parameters:
Bits per second - 57600
Data bits - 8
Parity - None
Stop bits" – 1
And sent the following commands to the modem
ATZ
AT+VCID=1
When i make a call to the line where the modem is connected it only respond:
RING
RING
RING
But it does not give me information about the telephone number that is calling. In the other hand i have test the line using a telephone with caller ID support and it Works correctly. I hope you can help me resolve this issue
Best Regards,
Hardware Version : Not Clear
Firmware Version :
ISP :
Hi:
I am trying to use the Caller ID Function of the TPLink TM-IP5600 but it does not work. I have try to use Putty 0.65 and use the following connection parameters:
Bits per second - 57600
Data bits - 8
Parity - None
Stop bits" – 1
And sent the following commands to the modem
ATZ
AT+VCID=1
When i make a call to the line where the modem is connected it only respond:
RING
RING
RING
But it does not give me information about the telephone number that is calling. In the other hand i have test the line using a telephone with caller ID support and it Works correctly. I hope you can help me resolve this issue
Best Regards,