Archer T9E install driver causes flashing screen and no access to Windows

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer T9E install driver causes flashing screen and no access to Windows

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer T9E install driver causes flashing screen and no access to Windows
Archer T9E install driver causes flashing screen and no access to Windows
2015-11-08 18:48:44
Model :

Hardware Version :

Firmware Version :

ISP :

Hi, Windows 8.TP-Link ac1900 Archer T9E PCIE Wirless Card.No graphics card.I install the drivers from either the disk or from the website. It goes through the motions, says installing driver, screen freezes and then the monitor starts flashing in vibrant colours and the computer is locked.Any ideas .Thanks.
  0      
  0      
#1
Options
2 Reply
Re:Archer T9E install driver causes flashing screen and no access to Windows
2016-11-10 16:56:07
Same problem here with Archer T9E, I have installed the latest drivers downloaded from the website, with these the problem is periodical (from time to time the display starts flashing with bright colors an the problem is still there even after a few reboots). Any answer?
  0  
  0  
#2
Options
Re:Archer T9E install driver causes flashing screen and no access to Windows
2016-12-12 17:18:15
The problem still exists, anyone?

Removing two of the three antennas solves the problem, but lower speed, lower signal, not a solution.

Thank you.
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 578

Replies: 2