When an EAP access point (e.g. EAP225) is being administered by my OC200 controller, there doesn't seem to be a way to monitor the Ethernet link speed through the Omada interface unless you are using a TP-link managed switch.  I have searched exhaustively to find the same link speed information for the EAP225 via the Omada interface, but it just does not seem to be there unless you are using a TP-link managed switch and accessing the speed of the link from the switch side.  Without a TP-link managed switch, the only way I have found to determine the link speed is to "Forget" the device and then access it directly after it has been forgotten by the controller.  In the EAP225's direct interface the Ethernet link speed is included in the Device Information under the Status heading as shown below:

Is there any reason the same link speed information cannot be included in the OC200 Omada interface, even when the EAP is connected via third party switch or unmanaged switch?