Deco M4R v2 revert to stock firmware failure
Deco M4R v2 revert to stock firmware failure
Good day,
I followed below to flash my deco to openwrt
https://forum.openwrt.org/t/openwrt-support-for-tp-link-deco-m4r/68940/144?page=8
Anyway openwrt did not go well for me with mesh network.
So, please advise about the proper way to revert back to stock firmware since i could not find it on the web.
Thanks.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Winded Yeah exactly i used HTTP method which is recommended by TP-LINK for Deco M4 and uploaded 1.8.2 firmware.
- Copy Link
- Report Inappropriate Content
@Winded Use Recovery Mode to revert back to official firmware.
- Copy Link
- Report Inappropriate Content
@ARGamingPK1 I did with many versions some are doing nothing while others like 1.8.2 is just ended by steady red light without booting up again.
Thanks.
- Copy Link
- Report Inappropriate Content
@Winded Did u try to install official firmware directly from OpenWRT ? i think you brick your Deco M4.
- Copy Link
- Report Inappropriate Content
@ARGamingPK1 Yes I tried and my 2X decos are good with recovering to openwrt using same steps.
I tried many methods with failure but not a programmer yet.
Thanks.
- Copy Link
- Report Inappropriate Content
@Winded I tried OpenWRT too but the 5 GHz wifi performance and range is very slow. I have also reverted to official tplink firmware.
- Copy Link
- Report Inappropriate Content
@ARGamingPK1 Same for me :(
Would you please let me know how did you manage to revert and is your deco also M4R V2.
Thanks.
- Copy Link
- Report Inappropriate Content
@Winded Yeah i have reverted back by using Recovery Mode from the link below and yes mine is also Deco M4 V2.
https://www.tp-link.com/us/support/faq/2958/
- Copy Link
- Report Inappropriate Content
@ARGamingPK1 So you used HTTP method not TFTP and uploaded last update 1.8.2 right?
- Copy Link
- Report Inappropriate Content
@Winded Yeah exactly i used HTTP method which is recommended by TP-LINK for Deco M4 and uploaded 1.8.2 firmware.
- Copy Link
- Report Inappropriate Content
@ARGamingPK1 Thank you so much reverting was done.
My mistake was not paying attention to led lights colors.
Thank you again.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 266
Replies: 11
Voters 0
No one has voted for it yet.