tp link 801ND client mode connected to multiple devices
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
tp link 801ND client mode connected to multiple devices
Model :
Hardware Version :
Firmware Version :
ISP :
Hi,
I have in my home network the following setup:
main router, which serves as the dhcp.
tp link 801ND set up as an access point connected to router via cable
tp link 801ND set up at client mode, connected via wifi to the latter access point.
I have a few wired devices in the same room I want to connect, so I connected them to a switch and connected the tp link in client mode to the same switch.
This seems to work for a few minutes, and then it stops and the devices don't manage to connect to my network again.
It does the same thing if I skip the switch and connect only one device to the tp link.
What am I doing wrong? why won't it work?
Hardware Version :
Firmware Version :
ISP :
Hi,
I have in my home network the following setup:
main router, which serves as the dhcp.
tp link 801ND set up as an access point connected to router via cable
tp link 801ND set up at client mode, connected via wifi to the latter access point.
I have a few wired devices in the same room I want to connect, so I connected them to a switch and connected the tp link in client mode to the same switch.
This seems to work for a few minutes, and then it stops and the devices don't manage to connect to my network again.
It does the same thing if I skip the switch and connect only one device to the tp link.
What am I doing wrong? why won't it work?