C3150, 2.4GHz channel resets after power cycle

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

C3150, 2.4GHz channel resets after power cycle

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
C3150, 2.4GHz channel resets after power cycle
C3150, 2.4GHz channel resets after power cycle
2016-12-11 19:39:04
Model :

Hardware Version :

Firmware Version :

ISP :

Bought C3150 yesterday. All setup is complete and it is working.
But,,, After power off the on, the channel of 2.4GHz leaps back to 1 which is the default value. I have set it to 9 before power cycle and saved.
Strangely, even the actual RF wave is at channel 1, the setup page shows channel 9. It goes back to channel 9 when I hit the save button again.
The problem is reproducible.
5GHz channel stay as I set, after power cycle.

Should I return this one as defective? Or can I expect firmware update?

The HW vrsion is V2, firmware is 0.1.00.9.1 V005f.0 Build 160920.
Tak
  0      
  0      
#1
Options
2 Reply
Re:C3150, 2.4GHz channel resets after power cycle
2016-12-14 16:02:59
Hello takfuji,
Have you tried to reset the router and reconfigure it again?
In addition, please tell me if you have enabled the smart connect feature.
Thanks.
  0  
  0  
#2
Options
C3150, 2.4GHz channel resets after power cycle
2016-12-16 08:30:08
Thanks, tplink,
The answer is yes and yes.

I thought I have closed this thread a few days ago, but the post does not appear.
As there were other problems on this router, I returned the product, so, I close the thread.
Tak
  0  
  0  
#3
Options