WR841HP - access control does not work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

WR841HP - access control does not work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WR841HP - access control does not work
WR841HP - access control does not work
2017-06-02 14:47:23
Model :

Hardware Version :

Firmware Version :

ISP :

Hi!
My Time Zone is setting to GMT -3:00
Firmware Version: 3.16.9 Build 151201 Rel.38446n
Hardware Version: WR841HP v2 00000000

I have created several Schedule Settings and assign them to a range of IPs, but none works.
In one of these Schedule Settings I want to block all Internet access all day long. I tried with no Target Settings, but it did not work. Then I created a configuration using only HTTP, in order to block any site, it also did not work, even for the other Schedule Settings.
First of all, I created a range of IPs in DHCP reservation, so I created an ARP biding using the same DHCP parameters, so I activated the ARP biding.
I set a Host for the desired IP range, a Schedule, for example, (Mon Tue Wed Thu Fri) 00:00 - 14:00.
When I created the rule to turn these settings on I did not set Target at first time.The default filter policy is Deny and the Internet Access Control is on.
  0      
  0      
#1
Options
1 Reply
Re:WR841HP - access control does not work
2017-07-21 15:09:05
when you choose deny, then you need to create a rule and select your host and any target, your schedule. Then these hosts can not access internet at the schedule time you have setup for them. But out of the time, they can access internet.
  0  
  0  
#2
Options