TP-Link Archer C1200 initializes Quick Setup every time I login
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-Link Archer C1200 initializes Quick Setup every time I login
Model :
Hardware Version : v1
Firmware Version : 1.0.1 Build 20160918 rel.37066 (EU)
ISP :
Hello,
I bought the Archer C1200 yesterday. I noticed that every time I log into the router it asks me to set up a new username and password. Basically, initializes the Quick Setup procedure.
I finished it couple of times successfully and clicked "Save". I have performed factory reset, but there is no difference.
What could be the problem?
Update: I found out that there was a newer firmware released which was not shown in the country I reside. On "Worldwide" all firmware version are shown. The latest 170616 version fixed the issue for me. Link
Hardware Version : v1
Firmware Version : 1.0.1 Build 20160918 rel.37066 (EU)
ISP :
Hello,
I bought the Archer C1200 yesterday. I noticed that every time I log into the router it asks me to set up a new username and password. Basically, initializes the Quick Setup procedure.
I finished it couple of times successfully and clicked "Save". I have performed factory reset, but there is no difference.
What could be the problem?
Update: I found out that there was a newer firmware released which was not shown in the country I reside. On "Worldwide" all firmware version are shown. The latest 170616 version fixed the issue for me. Link