c3200 access point
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
c3200 access point
Model :
Hardware Version :
Firmware Version :
ISP :
Hi
have the C3200 and want it to run in access mode i have tried disabling dhcp and it works fine for wired connections but as already mentioned on the group wifi just will not work as no ip address gets assigned to them, you would think there would be an option for ap mode in the firmware is there anyway to get it to work or any new firmware due out? or do i have to sell this and go netgear.
Hardware Version :
Firmware Version :
ISP :
Hi
have the C3200 and want it to run in access mode i have tried disabling dhcp and it works fine for wired connections but as already mentioned on the group wifi just will not work as no ip address gets assigned to them, you would think there would be an option for ap mode in the firmware is there anyway to get it to work or any new firmware due out? or do i have to sell this and go netgear.