VR600 IPv6 Tunnel issue
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
VR600 IPv6 Tunnel issue
Model :
Hardware Version :
Firmware Version :
ISP :
Hi,
firstly VR600 router is a great device, worth every penny. I’ve replaced Netgear D7000 with TP-Link after struggling with Wi-Fi reliability for over 3 months. Stability and features are not comparable (TP-Link is much better and cheaper – almost £60 difference!).
The only issue I’ve found is with IPv6 Tunnel type 6RD and IPv6 LAN addressing.
In tunnel configuration, when entering prefix length higher than 32 (have IP prefix /48 assigned to my tunnel) message popping up saying:
Error code: 86252
Please enter a 6rd prefix length between 1 and 32.
Also as I have routable prefix of /48 assigned by HE.net noticed that maximum prefix I can enter in LAN configuration is /64.
Error code: 86204
The prefix length must be 64.
Can support look into the case please?
Firmware Version:0.2.0 0.9.1 v0074.0 Build 170504 Rel.68210n Hardware Version:Archer VR600 v2 00000000
Regards
Vahanoi
Hardware Version :
Firmware Version :
ISP :
Hi,
firstly VR600 router is a great device, worth every penny. I’ve replaced Netgear D7000 with TP-Link after struggling with Wi-Fi reliability for over 3 months. Stability and features are not comparable (TP-Link is much better and cheaper – almost £60 difference!).
The only issue I’ve found is with IPv6 Tunnel type 6RD and IPv6 LAN addressing.
In tunnel configuration, when entering prefix length higher than 32 (have IP prefix /48 assigned to my tunnel) message popping up saying:
Error code: 86252
Please enter a 6rd prefix length between 1 and 32.
Also as I have routable prefix of /48 assigned by HE.net noticed that maximum prefix I can enter in LAN configuration is /64.
Error code: 86204
The prefix length must be 64.
Can support look into the case please?
Firmware Version:0.2.0 0.9.1 v0074.0 Build 170504 Rel.68210n Hardware Version:Archer VR600 v2 00000000
Regards
Vahanoi