help needed: POE injector / wireless transmission
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
help needed: POE injector / wireless transmission
Model :
Hardware Version :
Firmware Version :
ISP :
Hello everyone
I just registered in search for help for an unusual idea that maybe could work, but I'd like to have a qualified opinion about.
The subject:
the Kemper Profiler (KPA) is a famous digital guitar amp simulator, that uses a ethernet cable to connect to its remote controller, exchanging data and powering it.
I always supposed that electronically it used some proprietary signal management, but in some forum appeared a photo of a KPA using POE150S to avoid damage to the connector in case of unintentional pulling of the cable (you never know what can happen on stage...).
Now: the remote control is powered through the cable and uses a standard network equipment, so I think it exchanges data using ethernet standard
The question: what could I try/investigate, to add a wireless data transmitter and receiver so that I can completely get rid of the cable?
Anyone willing to share some thought?
If it worked, it would be a great, much appreciated solution! ;)
Thank you in advance to anyone willing to help
Enrico
(attached there is a photo of the equipment that started the discussion... )
Hardware Version :
Firmware Version :
ISP :
Hello everyone
I just registered in search for help for an unusual idea that maybe could work, but I'd like to have a qualified opinion about.
The subject:
the Kemper Profiler (KPA) is a famous digital guitar amp simulator, that uses a ethernet cable to connect to its remote controller, exchanging data and powering it.
I always supposed that electronically it used some proprietary signal management, but in some forum appeared a photo of a KPA using POE150S to avoid damage to the connector in case of unintentional pulling of the cable (you never know what can happen on stage...).
Now: the remote control is powered through the cable and uses a standard network equipment, so I think it exchanges data using ethernet standard
The question: what could I try/investigate, to add a wireless data transmitter and receiver so that I can completely get rid of the cable?
Anyone willing to share some thought?
If it worked, it would be a great, much appreciated solution! ;)
Thank you in advance to anyone willing to help
Enrico
(attached there is a photo of the equipment that started the discussion... )
Re:help needed: POE injector / wireless transmission
e_del wrote
Model :
Hardware Version :
Firmware Version :
ISP :
Hello everyone
I just registered in search for help for an unusual idea that maybe could work, but I'd like to have a qualified opinion about.
The subject:
the Kemper Profiler (KPA) is a famous digital guitar amp simulator, that uses a ethernet cable to connect to its remote controller, exchanging data and powering it.
I always supposed that electronically it used some proprietary signal management, but in some forum appeared a photo of a KPA using POE Injector 150S to avoid damage to the connector in case of unintentional pulling of the cable (you never know what can happen on stage...).
Now: the remote control is powered through the cable and uses a standard network equipment, so I think it exchanges data using ethernet standard
The question: what could I try/investigate, to add a wireless data transmitter and receiver so that I can completely get rid of the cable?
Anyone willing to share some thought?
If it worked, it would be a great, much appreciated solution! ;)
Thank you in advance to anyone willing to help
Enrico
(attached there is a photo of the equipment that started the discussion... )
It is hard to find the same shape of this poe injector,maybe you can get it on alibaba or amazon.But as I know the price on amazon is very expensive.