Deco M5 in AP-mode
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco M5 in AP-mode
Model :
Hardware Version :
Firmware Version :
ISP :
Hello,In addition to using my Deco M5 units in AP-mode, I would like them to be connected via ethernet so none of the wireless bandwidth is used for the communication between the Deco units. I have already built this set-up in the following manner. An ethernet cable is connected from my modem/router to an unmanaged 8-port switch. Al the Deco units are connected to the switch via ethernet.Because I only see low wireless speeds (60 Mbps) I suspect that the ethernet connections aren't working properly. Could you please tell if I have wired the set-up corectly?Thank you for your response in advance.With kind regards,Daan de Vos
Hardware Version :
Firmware Version :
ISP :
Hello,In addition to using my Deco M5 units in AP-mode, I would like them to be connected via ethernet so none of the wireless bandwidth is used for the communication between the Deco units. I have already built this set-up in the following manner. An ethernet cable is connected from my modem/router to an unmanaged 8-port switch. Al the Deco units are connected to the switch via ethernet.Because I only see low wireless speeds (60 Mbps) I suspect that the ethernet connections aren't working properly. Could you please tell if I have wired the set-up corectly?Thank you for your response in advance.With kind regards,Daan de Vos