TP Link TL-WR940N DHCP Settings Greyed Out and Unable to Change
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP Link TL-WR940N DHCP Settings Greyed Out and Unable to Change
Model :
Hardware Version :
Firmware Version :
ISP :
Hi All,
I am trying to set up a Smart DNS on my TP Link router. The instructions I'm following are telling me to enable the DHCP settings (which was on by default) and then enter my Smart DNS server address into Primary DNS section.
All part on the DHCP settings are greyed out so I am unable to change any settings or input any address.
It's a brand new router that I purchased today, so I am unsure if there is any setting(s) that I have turned off by default that prevents me from inputting anything on the DHCP settings page.
Hardware Version :
Firmware Version :
ISP :
Hi All,
I am trying to set up a Smart DNS on my TP Link router. The instructions I'm following are telling me to enable the DHCP settings (which was on by default) and then enter my Smart DNS server address into Primary DNS section.
All part on the DHCP settings are greyed out so I am unable to change any settings or input any address.
It's a brand new router that I purchased today, so I am unsure if there is any setting(s) that I have turned off by default that prevents me from inputting anything on the DHCP settings page.