Cant find correct settings in Archer C7
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Cant find correct settings in Archer C7
Model :
Hardware Version :
Firmware Version :
ISP :
Hi all,
We've recently got a new Archer C7 router and checked with our ISP if it was compatible with our network. They said it'll be if we adhere to these settings:
WAN Protocol: MAC Encapsulated Routing
WAN1 1p/VLAN ID: 1/34
WAN3 1p/VLAN ID: 5/4
PPPoE passthrough function: Enable
IP-adres: 192.168.2.254
Duplex Mode: Auto
Max Bit Rate: Auto
DHCP Server, pool Start IP: 192.168.2.1
DHCP Server, pool End IP: 192.168.2.252
And I've look through the entire basic and advanced settings via the webinterface; I can't find most of these settings. Others I did find I was reluctant to just change, because the network works (the WiFi signal is fine) but the incoming internet connection can be spotty. Resetting the router does seem to do the trick, but I hope adding these above settings can make it a good stable connection.
Can anyone help me, please? :)
Hardware Version :
Firmware Version :
ISP :
Hi all,
We've recently got a new Archer C7 router and checked with our ISP if it was compatible with our network. They said it'll be if we adhere to these settings:
WAN Protocol: MAC Encapsulated Routing
WAN1 1p/VLAN ID: 1/34
WAN3 1p/VLAN ID: 5/4
PPPoE passthrough function: Enable
IP-adres: 192.168.2.254
Duplex Mode: Auto
Max Bit Rate: Auto
DHCP Server, pool Start IP: 192.168.2.1
DHCP Server, pool End IP: 192.168.2.252
And I've look through the entire basic and advanced settings via the webinterface; I can't find most of these settings. Others I did find I was reluctant to just change, because the network works (the WiFi signal is fine) but the incoming internet connection can be spotty. Resetting the router does seem to do the trick, but I hope adding these above settings can make it a good stable connection.
Can anyone help me, please? :)
