Archer c2 ac750 Broken
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer c2 ac750 Broken
Model :
Hardware Version :
Firmware Version :
ISP :
I have Archer c2 ac750 router broken and I tried to flash the latest firmware "Archer C2(EU)_V1_170207" using tftpd64, after it finished transferring the firmware I waited for 8 min and then I power it manually off and on. After that I got the power LED only turned on and I am unable to access the router settings since the connection is not able to have an IP address and I have tried to set as static (192.168.0.1 or 192.168.1.1) but with no luck.
I tried to hookup a WAN connection and I got the LAN ports working as a bridge (I got an IP address from the WAN connection to LAN ports). But I still cant access the router settings.
I tried to hard reset the router by holding the reset button while power it off and on and I got no results. But when I power it on while holding the reset button the internet LED blinks only once.
Is there any solution or guide to have my router work again. Thank you.
Is it possible to flash the firmware through UART?
Hardware Version :
Firmware Version :
ISP :
I have Archer c2 ac750 router broken and I tried to flash the latest firmware "Archer C2(EU)_V1_170207" using tftpd64, after it finished transferring the firmware I waited for 8 min and then I power it manually off and on. After that I got the power LED only turned on and I am unable to access the router settings since the connection is not able to have an IP address and I have tried to set as static (192.168.0.1 or 192.168.1.1) but with no luck.
I tried to hookup a WAN connection and I got the LAN ports working as a bridge (I got an IP address from the WAN connection to LAN ports). But I still cant access the router settings.
I tried to hard reset the router by holding the reset button while power it off and on and I got no results. But when I power it on while holding the reset button the internet LED blinks only once.
Is there any solution or guide to have my router work again. Thank you.
Is it possible to flash the firmware through UART?
