How enable Web Managment via telnet?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How enable Web Managment via telnet?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How enable Web Managment via telnet?
How enable Web Managment via telnet?
2020-05-16 21:03:30
Model: TD-W9970  
Hardware Version:
Firmware Version:

I lost web access to my TP-LINK. I ran an NMAP and saw that the web port (HTTP, 80) is not enabled. It appears that Web Managment (Access / Remote Control) is disabled.

 

I was able to connect via telnet (port 23) successfully. How can I enable web management (HTTP) again?

 

I cannot reset the settings because I will lose the settings and will need to activate my ISP.

  0      
  0      
#1
Options
1 Reply
Re:How enable Web Managment via telnet?
2020-05-16 21:53:17

I to solve it.

I identified by NMAP that the ISP changed the management port to 8090, identified by 8090 / tcp open opsmessaging in NMAP.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1778

Replies: 1

Related Articles