Archer C5400X - IPv6 with BT Fibre

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C5400X - IPv6 with BT Fibre

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C5400X - IPv6 with BT Fibre
Archer C5400X - IPv6 with BT Fibre
2020-05-30 10:42:44
Model: Archer A2300  
Hardware Version: V1
Firmware Version: 1.1.2

I recently purchased this router to replace an old Netgear Nighthawk R7000.

 

I have followed all the setups and can connect to my ISP (BT Fibre 2) without any problem. However, I am unable to establish an IPv6 connection using any of the usual BT settings. Does anyone know if this router is actually able to establish  IPv6 on BT or has suggestions on any other settings i could try. Each time I change settings and reboot with IPv6 switched on in the menu, the router just drops and re-estblishes connection every few seconds.

 

I currently connect through a Draytek Vigor 130 in bridged mode and IPv6 worked ok on the Netgear router.

 

 

This is my first TP-Link purchase and it does not bode well when the support forum does not even list it as a device to choose when posting frown

  0      
  0      
#1
Options

Information

Helpful: 0

Views: 663

Replies: 0

Related Articles