Port Forwarding NOT WOKRING

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Port Forwarding NOT WOKRING

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Port Forwarding NOT WOKRING
Port Forwarding NOT WOKRING
2020-07-13 13:51:29 - last edited 2020-07-20 07:51:50
Model: TL-MR6400  
Hardware Version: V4
Firmware Version: 1.10.0

Hi Everyone, 

 

I am trying to host a website on a Raspberry Pi. I am currently using this router in the LTE configuration with an EE sim. I have set up a virtual server pointed toward the IP that I reservered and bound to my Raspberry Pi's MAC address. However, when I try and access this from a device not connected on the LAN, I can't connect to the website. I have also used the port-forwarding tester which has show that the port number is blocked on my IP. Anyone have any idea why this is happening? 

  0      
  0      
#1
Options
1 Reply
Re:Port Forwarding NOT WOKRING
2020-07-22 02:22:05 - last edited 2020-07-22 03:03:33

@ign3u5 

Hello,

 

To precisely locate the current issue, please try the following suggestions: 


1. Please login to the TP-link web page as the FAQ:
Login FAQ for Archer MR6400:https://www.tp-link.com/en/support/faq/2838/

 

And go to Advanced-> Status --> Internet --> IP address (for MIFI: Status--> IPv4 address) to check your WAN IP address.


Please go to what'smyIP website to check the real public IP address :
https://www.whatismyip.com/


Compare the " WAN IP" and real public IP address on what'smyIP website, if they are Different, that means your ISP assigns a private IP/limited IP for 3G 4G router andISP side still have a NAT device that blocks the ports. 


Please contact your ISP and let them release a real public WAN IP for your router. 


2. If they are the same, please refer to this FAQ to check the Port forwarding settings: https://www.tp-link.com/en/support/faq/1685/


3. Please turn off the firewall on Server or host side.

 

If you need any further help, please help confirm the information below:


1. May I know why do you need to open ports? What is the IP and gateway of that device/ service?


2. Can you access the device/ service under the local network? How do you access it, for example by putting in the IP address in a Web page, our App? 


3. Please send us a photo of the TP-Link Status page and a photo of what'smyip. 


4. What is the Error message when you access the device/service remotely, please send us a photo of the Error. 


5. Please let us know the fimware& hardware version of the tp-link device.
https://www.tp-link.com/en/support/faq/315/

 

May it help and have a nice day!

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 663

Replies: 1

Related Articles