Deco M4 as AP - an CPE510 as client cannot see the AP
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco M4 as AP - an CPE510 as client cannot see the AP
I have an operational two Deco M4 mesh working. Would like to connect a CCTV camera to this network using CPE510. Setup the CPE as client mode and let it scan for Deco SSID within the same room but it cannot found Deco. The CPE discover nearby SSID fine. Is it possible that there were too close? Or Deco and CPE510 operate on different 5GHz channels? Both Deco and CPE are at the current firmware. The CPE HW is 3.2
Regards
Kanok
1 Accepted Solution