Home Network Community > All Threads > how to set Bandwidth Control at TD-W9960
< All Threads

how to set Bandwidth Control at TD-W9960

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

how to set Bandwidth Control at TD-W9960

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
how to set Bandwidth Control at TD-W9960
how to set Bandwidth Control at TD-W9960
2020-08-01 22:46:23
Model: TD-W9960  
Hardware Version: V1
Firmware Version: 1.0.0 0.8.0 v009d.0 Build 181115 Rel.61497n

hey everyone 

i have enabled Bandwidth Control but i can see Controlling Rules is not working at all

even when i put the role it is not working

as you guys can see in the pic..i'm puting 1536kb download but what actually happen 

the download is 5120 which is the whole bandwidth control so rules don't take action..why!!!!

  1      
 
  1      
 
#1
Options
2 Reply
Re:how to set Bandwidth Control at TD-W9960
2020-08-03 07:53:26

@salah1 

Hello!

Could you please help us check the following information：

1. If you run one more device which is out of the limited IP range, then test these three devices within the IP range, would the final speed be limited to 1536kbps?

2. And please try to disconnect these three devices and reconnect, after that, please test the speed again to see if it would be limited.

 

Thank you very much.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options
Re:how to set Bandwidth Control at TD-W9960
2020-08-03 11:41:15

@Sunshine hi

 

i'm already set Address Reservation

and i set the role before 

bandwidth control only works with guest network

 

 

  0  
  0  
#3
Options

Information

Helpful: 1

Views: 785

Replies: 2

Related Articles
TD-W9960 bandwidth control error with lan port
109 0
enabling bandwidth control on TD-W9960 slows overall download speed
722 0
TD-W9960 latest update error
1361 0
TD-W9960 Configuration
1601 0
recovery setup TD-W9960
564 0
Default firmware for TD-W9960
766 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.