Cannot connect via Ethernet, WiFi fine
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Cannot connect via Ethernet, WiFi fine
Hello, purchased new router this week replacing BT Home Hub 5 and WiFi is great but on Tuesday and Wednesday initially no speed for about 15 minutes each day although pc says connected. Today hour after turning on still no speed although showing connected. Latency 246. Ethernet status showing 11,000,000,000 bytes on startup.
Grateful for any advice.
Re:Cannot connect via Ethernet, WiFi fine
Good day.
Thank you for your patience.
Please refer to the following suggestions:
- change the DNS and MTU on the modem to have a look;
- make sure there Is no access control or mac filtering for this computer;
- if possible, fetch one more Ethernet device to see what happened;
Thank you~
Nice to Meet You in Our TP-Link Community.
Check Out the Latest Posts:
Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router
EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller.
Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability.
TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode.
If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.