Internet works but no wifi

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Internet works but no wifi

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Internet works but no wifi
Internet works but no wifi
2020-09-07 15:02:39 - last edited 2020-09-09 10:10:07
Model: Archer VR600  
Hardware Version:
Firmware Version:

Hi 

Just did a reset for the router. 

The cable Internet works fine, but the WiFi doesn't. 

It connects but there is no Internet connection. 

 

Tried turning off and on both the router and the laptop but it doesn't help 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Internet works but no wifi-Solution
2020-09-09 10:09:47 - last edited 2020-09-09 10:10:07

@Moranr 

Good day.

May I know the hardware and firmware version about Archer VR400

Before reset, did both wired connections and wireless connections work fine?

On the front of the router, did the internet light it up and at the back of the VR400, which port is connected to the ISP, DSL port or LAN/WAN port?

Have you tried to  change the wireless settings, like channel and channel width on the router, such as:

https://www.tp-link.com/en/support/faq/2794/

 

Could you please also send me a picture of the advanced>status>internet page on the modem?

Thank you very much!

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Internet works but no wifi-Solution
2020-09-09 10:09:47 - last edited 2020-09-09 10:10:07

@Moranr 

Good day.

May I know the hardware and firmware version about Archer VR400

Before reset, did both wired connections and wireless connections work fine?

On the front of the router, did the internet light it up and at the back of the VR400, which port is connected to the ISP, DSL port or LAN/WAN port?

Have you tried to  change the wireless settings, like channel and channel width on the router, such as:

https://www.tp-link.com/en/support/faq/2794/

 

Could you please also send me a picture of the advanced>status>internet page on the modem?

Thank you very much!

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options