Line Attenuation = 0 dbm, at tp link adsl2+ (new router age 1day)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Line Attenuation = 0 dbm, at tp link adsl2+ (new router age 1day)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Line Attenuation = 0 dbm, at tp link adsl2+ (new router age 1day)
Line Attenuation = 0 dbm, at tp link adsl2+ (new router age 1day)
2020-09-13 22:50:28 - last edited 2022-11-27 16:23:55
Model: TD-W8961N  
Hardware Version: V3
Firmware Version: FwVer:3.24.13.0_MT7550 HwVeR:T14.F7_13.0

Nullnulll

  0      
  0      
#1
Options
1 Reply
Re:Line Attenuation = 0 dbm, at tp link adsl2+ (new router age 1day)
2020-09-16 11:09:21

@m.daqa 

Good day.

Sorry for the delay.

May I know what kind of DSL tester did you use

And can I have a picture that Attenuation Down Stream is equal to 4dbm on the DSL tester? And how about the upstream on the tester?

Did you have any specific issue which might be caused by the line attenuation?

By the way, where are you located and who is your internet service provider?

Thank you very much.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 961

Replies: 1

Related Articles