Archer MR600 IPSec Site VPN with IPv6 WAN Gateway

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer MR600 IPSec Site VPN with IPv6 WAN Gateway

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer MR600 IPSec Site VPN with IPv6 WAN Gateway
Archer MR600 IPSec Site VPN with IPv6 WAN Gateway
2020-11-05 13:23:27 - last edited 2020-11-06 01:32:23
Model: Archer MR600  
Hardware Version: V1
Firmware Version: 1.2.0 0.9.1 v0001.0 Build 200511 Rel.44954n

Is it possible to configure a IPSec Site VPN with two Archer MR600 routers with an native IPv6 WAN Address at each site? At the wan connection is no dual stack possible!

In short, does the IPSec implementation of this router support IPv6 gateways?

 

  0      
  0      
#1
Options
1 Reply
Re:Archer MR600 IPSec Site VPN with IPv6 WAN Gateway
2020-11-06 03:08:19

@Networker2020 

Good day,

Thank you very much for your time and patience.

After checking with the senior engineers, I am sorry that Archer MR600 does not support  IPv6 gateways on the IPSec Site VPN connection.

 

Really sorry for the inconvenience.

Thanks!

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 950

Replies: 1

Related Articles