Archer C4000 V2 NAT loopback issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C4000 V2 NAT loopback issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C4000 V2 NAT loopback issue
Archer C4000 V2 NAT loopback issue
2020-12-03 14:38:09 - last edited 2020-12-07 09:02:36
Model: Archer C4000  
Hardware Version: V2
Firmware Version: 1.1.1 Build 20190827 rel.78773(5553)

I am unable to access my internal servers via the external IP address from devices connected via ethernet to my router. 

 

Devices that are connected to wireless or vpn are able to access the interal servers correctly via port forwarding. 

 

Using either DDNS or WAN IP address I cannot access interal servers from a device on the local wired network, however i can access those servers via the interal IP address

 

it seems that the nat loopback issue was fixed on other devices in newere firmware but no this one. Any suggestions?

  0      
  0      
#1
Options
1 Accepted Solution
Re:Archer C4000 V2 NAT loopback issue-Solution
2020-12-03 14:43:57 - last edited 2020-12-07 09:02:36
https://community.tp-link.com/us/home/forum/topic/197094?replyId=415660 I guess not :(
Recommended Solution
  2  
  2  
#2
Options
1 Reply
Re:Archer C4000 V2 NAT loopback issue-Solution
2020-12-03 14:43:57 - last edited 2020-12-07 09:02:36
https://community.tp-link.com/us/home/forum/topic/197094?replyId=415660 I guess not :(
Recommended Solution
  2  
  2  
#2
Options

Information

Helpful: 0

Views: 770

Replies: 1

Related Articles