danymarc wrote

default ur TL-WA901ND with pin, then re-load firmware, just be carefull to select ur Hardware Version

danymarc wrote

http://www.tp-link.com/en/article/?faqid=202

khaleel_halawah wrote

ok but why what the benefit from reset device ?

danymarc wrote

I learned to red many years ago, and on ur post #1 reads this
I have Wireless Access Point model No : TL-WA901ND and I faced a lot of issue in this model sometimes this WAP do not work well until we reboot the device and then it work fine so please can you [I]help me[/I] ?
if I misunderstood something, please correct me
My answers r only suggestions, up to u if u decide to apply
NO OBLIGATION

khaleel_halawah wrote

Hi MR.Danymarc

Thank you for your response on this issue , yes you understood my issue and I ask you if I rest this device and I faced this issue again what I can do because I rest this device and reconfigure and then it not work fine?

danymarc wrote

i u have doubts, or not sure what ur going to do.
A non written rule with this toys, is always have urs updated to newest firmware.
1-Back up ur data, System Tools/Back Up & Restore/ u will see at center BACK UP button just click and save ur data file, folder it, as any name u identify, as old, first etc.
2-Reset ur RE, and reconfigure from scratch,
3-If u get everything back and going,, save the file again, (folder it, with another name u identify as the second) this is a good back up file.
4-Now u suppose to have a fresh back up file, every time u dont like something, just reset ur RE dont have to use pin, there is a tool in same area, System Tools, called Faxtory Default, just reset ur RE and load ur backed up file.
5-donf like it, remember on step 1 u backed up ur old data, as u have it right now, reset ur RE to defaults and load it, everything will go to back to the point ur right now